Pool Fence Height Requirements Nsw

Fences must not be higher than 1 8 metres.

Pool fence height requirements nsw. If the pool fence is not 1 2m high all the way around or only in some sections then the home owner should seek immediate advice from a licensed builder pool technician or fencing contractor. Pool fence height australian standard as 1926 1 stipulates that a pool fence shall be not less than 1 2m high all the way around. There are a number of factors that can result in a need for a planning permit in nsw. Be at least 1 2m high as measured from the finished ground level not leave a gap at the bottom bigger than 10cm from the finished ground level.

Make sure you have an approved legible cpr sign installed near the shallow end of your pool. Any gaps in the fencing must be less than 100mm. Key pool fence measurements. In nsw a pool fence must.

Pool fencing must be a minimum height of 1200mm. If a boundary fence is part of the pool fence the barrier should be 1800mm high from the pool area. Pool fencing in nsw must comply with the physical measurement requirements summarised below. Additionally there should be no more than 100mm gap between the fence bottom and the ground.

Any gaps must be filled with compliant materials. Fences must be constructed using post and wire or post and rail. Height of a pool fence must be at least 1 2m above the ground from finished ground level gap at the bottom of the pool fence must not be more than 10cm from finished ground level gaps between between any. The pool fence must be constructed from durable materials.

Masonry materials can be used within three metres either side of the entrance to the property from the primary road. Not have gaps of more than 10cm between any vertical bars in the fence. You can find out more specific information on the nsw planning portal. If a boundary fence is part of the pool fence the barrier must be 1 8m high.

If you have a boundary fence which is also a part of the pool barrier the height of the fence should be at least 1800mm unless your pool was built prior to 2008 and can comply with the earlier standard. The top of the fence must be a minimum of 900mm away from climbable objects including trees pergolas barbecues toys pot plants and furniture. Fences as exempt from development nsw planning portal website. As a pool owner you must understand that your pool fence should be at least 1200mm from ground level.

If you have a boundary fence that is also part of the pool barrier the boundary fence should be at least 1800mm in height. New south wales as a general rule a residential fence should not exceed 1 8m in height. When used electric fencing must be constructed in accordance with as nzs 3014 2003. The gap between the vertical bars in the fence should not exceed 100mm.

The gap from the bottom of the fence to the ground is no more than 100mm.